Thin-walled beams, shear flow and buckling of skins and stiffeners: how lightweight airframes carry load.
Key ideas
- Aircraft structures are thin-walled, so shear flow is used instead of shear stress alone.
- Closed sections are much stiffer in torsion than open sections.
- Thin skin panels buckle early; stiffeners carry the compressive load after that.
- The shear centre is where a load causes bending without twisting.
Formula sheet
Shear flowBredt–Batho (closed thin-walled torsion)Unsymmetric bendingOpen-section shear flowPlate buckling stressMargin of safety
Shear flow
q=\tau\,t
Bredt–Batho (closed thin-walled torsion)
T=2A_e\,q,\qquad \frac{d\theta}{dz}=\frac{T}{4A_e^2G}\oint\frac{ds}{t}
A_e = area enclosed by the wall mid-line
Unsymmetric bending
\sigma_z=\frac{M_xI_{yy}-M_yI_{xy}}{I_{xx}I_{yy}-I_{xy}^2}\,y+\frac{M_yI_{xx}-M_xI_{xy}}{I_{xx}I_{yy}-I_{xy}^2}\,x
Open-section shear flow
q_s=-\frac{S_y}{I_{xx}}\int_0^s t\,y\,ds\quad(\text{symmetric section})
Plate buckling stress
\sigma_{cr}=\frac{k\pi^2E}{12(1-\nu^2)}\left(\frac{t}{b}\right)^2
Margin of safety
MS=\frac{\text{allowable stress}}{\text{applied stress}\times FS}-1
Working on a project in Aircraft Structures? We can guide you step by step.
Ask on WhatsApp