Sizing shafts, gears, springs, bolts and bearings so they do not fail. Pair this with Strength of Materials for any design project.
Key ideas
- Pick a factor of safety based on how well you know the loads and the material.
- Ductile materials are checked with distortion energy (von Mises); brittle materials with maximum principal stress.
- Fatigue failure happens below yield stress under repeated loads.
- Standard sizes (from design data books) are chosen after calculation.
Formula sheet
Factor of safetyShaft diameter under torsionCombined bending and torsionPower transmitted by a shaftHelical springLewis equation for gear teethGoodman fatigue criterionBearing life
Factor of safety
FOS=\frac{\text{failure stress}}{\text{working stress}}=\frac{S_y}{\sigma}
Shaft diameter under torsion
d=\left(\frac{16T}{\pi\tau_{\text{allow}}}\right)^{1/3}
Combined bending and torsion
T_e=\sqrt{M^2+T^2},\qquad M_e=\tfrac12\left(M+\sqrt{M^2+T^2}\right)
Power transmitted by a shaft
P=\frac{2\pi NT}{60}
N in rpm, T in N·m, P in W
Helical spring
\tau=K_w\frac{8PD}{\pi d^3},\qquad \delta=\frac{8PD^3n}{Gd^4},\qquad K_w=\frac{4C-1}{4C-4}+\frac{0.615}{C}
C = D/d spring index
Lewis equation for gear teeth
\sigma_b=\frac{F_t}{b\,m\,Y}
Goodman fatigue criterion
\frac{\sigma_a}{S_e}+\frac{\sigma_m}{S_{ut}}=\frac{1}{FOS}
Bearing life
L_{10}=\left(\frac{C}{P}\right)^{p}\times10^6\ \text{revolutions}
p = 3 for ball bearings, 10/3 for roller bearings
Working on a project in Design of Machine Elements? We can guide you step by step.
Ask on WhatsApp